Diamond


Tile adhesive is a White (Glass Mosaic Adhesive) cement-based, highly polymer modified, high strength, flexible tile adhesive for fixing vitrified tiles and glass mosaics in interior and exterior situations. Suitable for walls and floors. Diamond Tile adhesive is non-slip and water-resistant and highly recommended for swimming pools and other water bodies.

Characteristics:



High bond strength

Flexible, improves work ability

Suitable for walls & floors

Improved adhesion to substrates

Resistance to water

Resistance to chemicals

Greatly reduced water and salts permeability

  • Recommended Substrates
  • Coverage
  • Technical Specification
  • Typical Value

Recommended Substrates

Recommended Substrates

Cured concrete

Masonry blocks

Cement backer - board

Water bodies like swimming pools

Existing glazed surfaces

Coverage

Coverage

This will depend on the nature and flatness of the surface and the method of application. It may cover approximately 50 to 60 sq.ft per 20 kg bag for bed thickness of 3mm. For good coverage, it is vitally important that all surfaces should be clean, smooth, plumb, level and free from defects and undulation.

Technical Specification

Bed Thickness Application Open Time Pot Life at
27 ⁰ + 2⁰ C
Setting Time at
27 ⁰ + 2⁰ C
Temperature Resistance
2-6mm Use Thin-Bed Trowel(Dry wall areas)
Use Thick-Bed Trowel (wet floor areas)
15-20 minutes 3 hours 24 hours -30⁰ C to 150⁰C

* Suitability depends on surface level/flatness p.b.w = Parts by Weight

Typical Value

Results at 27± 2⁰C Tensile Adhesion (14 day air) Shear Adhesion
Dry Condition (kN) Dry Condition (kN) Wet Condition (kN) Heat Condition (kN)
Diamond 2.00 18.00 10.00 10.00
BS.5980 : 1980 minimum 0.95 8.90 4.50 4.50
IS 15477 : 2004 minimum Type2 1 Day Air 14 Day Air 7 Day Air/ 7 Day Wet 7 Day Air/ 7 Day Heat
4.00 10.00 5.00 5.00